Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Brake system
   10.1. Technical data
   10.2. Prorolling of hydraulic brake system
   10.3. Brake pipelines and hoses
   10.4. Replacement of lobbies brake колодок
   10.5. Replacement back brake колодок
   10.6. Replacement back brake колодок on drum-type brakes
   10.7. A forward brake disk
   10.8. A back brake disk
   10.9. A back brake drum
   10.10. A support of a forward brake
   10.11. A support of a back wheel
   10.12. The back brake cylinder
   10.13. The main brake cylinder
   10.14. A brake pedal
   10.15. The vacuum amplifier of brakes
   10.16. The unilateral valve of the vacuum amplifier of brakes
   10.17. Adjustment of a manual brake
   10.18. The lever of a manual brake
   10.19. A cable of a manual brake
   10.20. Brake колодки a manual brake (model with disk brakes)
   10.21. The valve of adjustment of pressure in brake system
   10.22. The stoplight switch
   10.23. Antiblocking system of brakes (ABS)
   10.24. The vacuum pump (cars with the diesel engine)
   10.25. Check of the vacuum pump on cars with diesel engines
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions



10.14. A brake pedal

Removal

PERFORMANCE ORDER
1. Remove the negative plug from the accumulator.
2. Uncover boxes with fuses. Disconnect a socket from key колодки, unscrew screws of fastening and remove the bottom furnish of the panel of devices from outside the driver.
3. Remove скобу fastenings and take a pin with a head and an aperture under шплинт, крепящий a pusher of a pedal of a brake with the vacuum amplifier.
4. Unscrew a nut шарнирного a bolt and remove a brake pedal from the car.

Installation

PERFORMANCE ORDER
1. Grease with universal greasing a lining and insert it into an aperture of a point of turn of a pedal.
2. Establish a brake pedal into place. Thus check up, that the pusher became on the place. Insert шарнирный a bolt and fix a nut.
3. Combine a pedal with a pusher and insert a pin with a head and an aperture under шплинт and fix it скобами.
4. Establish the bottom furnish of the panel of devices and connect the accumulator.